By pressing “0” key, to enter the receiving status of surveillance system at the FAR END
of OmniEyes-37A.

(2) By dialing digital-key to input telephone number and password.

(3) [a] A digit-backward-key.
[b] To convert Tone / Pulse key.
[c] To operate “ON” connector, when connecting the FAR END of OmniEyes-37A with
Controller-37A.

To provide a set of connector for “OFF” function, when FAR END of OmniEyes-37A
connecting with Controller-37A.

(5) After inputting a set of number, press ENTER key for execution.

(6) A termination key to cut off telephone line and to exit the system.

To press two keys at same time for 10 seconds, after words “SET PASSWORD” showing
on screen, then setting up your password.

To press two keys at the same time for 3 seconds, image showing On Channel-A. Then
pressing Channel-B, C or D respectively.

To press this key for showing a QUAD (4 images) on monitor.

[a] To press the key for “TRACING SCREEN” shown on full screen of the FAR END.
[b] To press this key for auto PAN rotating function of Far End, but only when the
image is displayed on “1/4 Screen” of Channel-A.

[a] To press ARROW for moving the “TRACING SCREEN” UP, DOWN, RIGHT or
LEFT.
[b] To press any key (UP, DOWN, LEFT, RIGHT) to stop auto PAN rotating function of
FAR END, then press “1/8 Screen” key to operate ARROW (UP, DOWN, LEFT,
RIGHT) key to control Pan/Tilt rotation at MANUAL status on FAR END of
OmniEyes-37A.

To press either “NEAR” or “FAR” key, for operating the Zoom Lens, (Zoom-in / Zoom-
out), only when image shown in “1/8 Screen” on Channel-A at the FAR END of
OmniEyes-37A.

To press “1/8 SCREEN” “1/4 SCREEN” or “FULL SCREEN” at your option for desired image size on the FAR END of OmniEyes-37A.

To press “RESET” + “1” keys at the same time, to test whether all the function keys are
in normal condition. To press either “NEAR” or “FAR” key, then pressing “RESET”
key to test Zoom-in / Zoom-out of Zoom Lens.